California motorcycle license plate restore or transform

Description

DIY California License  Plate
T
RANSFORMATION / RESTORATION kit
MADE IN THE USA
Quick and easy transformation of your license plates.
It takes LESS than 5 minutes to
install
this decal set.
NO NEED TO SPEND EACH PLATE FOR SOMEONE ELSE TO DO IN UNEVEN THICKNESSES OF THE LETTERS WHEN YOU CAN EASILY ACCOMPLISH YOURSELF FOR ALLOT LESS
copy & paste to you tube for instructions:
https://youtu.be/sJbmdyt8ZWo
YELLOW DECAL SET TO USE ON A BLACK  OR BLUE PAINTED LICENSE PLATE (ORDER YELLOW):
The digits requested x2 (you only need 1 but I supply extras just in case)
CAL x2
BLUE DECAL SET TO RESTORE A WHITE LICENSE PLATE (CHOOSE BLUE):
The digits requested x4 (you only need 1 but I supply extras just in case)
CAL x2
Instructions:
• Take a photograph of your license plate. Be sure to take the picture straight forward not at any angle. at the time of purchase there is an option to send a message to the seller send the picture. This is to ensure the correct font is sent to you as the DMV used different fonts throughout the years. We have them all but we need to make sure you get the right ones
Then
• Remove your license plates from the vehicle
• Clean your license plates
• Mask the month and year stickers
• Using a “0000” steel wool pad OR green scuff pad  (sold at any hardware store for about ) scuff the surface of the plate to ensure paint adherence.
DO NOT USE SAND PAPER OR A WIRE WHEEL THIS WILL CAUSE DEEP GROOVES ON YOUR PLATE DUE TO THE CHEAP MATERIAL CURRENTLY (white plates) USED BY THE DMV (BELIEVE ME I know I’ve made that mistake) older Plates like original blue and black plates are better metal and can have sand paper or wire wheels used on them.
• paint your plates (you can use a good quality spray can if you do not have a paint gun, remember the cheaper the paint, the more coats you will need. I found that a good quality paint does the job with one coat)
• Once your license plate is dry to the touch
using an exacto knife, knife, or even a tooth pick lift off the "C" and place in to position. using your finger rub in to place and then continue with "A" and finally "L"
then using a 3/4" masking tape piece about 2" long, slice the tape in half leaving two 3/8' pieces 2 inches long (do not use scotch clear)
place over your first digit (be sure to use a straight edge of the digit to guide the tape so you can guide it) rub your finger over the digit and lift the letter off the sheet and place on the license plate digit using the straightest edge as a guide.
Rub your finger nail over the digit from the center of the digit out top to bottom or left to right
Lift the transfer tape slowly and gently (if for some reason the digit lifts up with the tape place it back down and rub down again this is rare but it could happen so in case of any error we supply extras)
• Repeat for every digit
• Your plate is done.
if you have any questions please message us prior to purchasing so we can clearly cover any details you may have questions about.
FOR A VIDEO TUTORIAL of SIMILAR KIT
COPY AND PASTE TO YOUR
WEB BROWER THIS YOU TUBE LINK:
https://youtu.be/sJbmdyt8ZWo
OR SEARCH FOR: DIY CALIFORNIA LEGACY PLATES